central dust removal system belongs to mechanical dithering dust remover. Its basic structure consists of fan, filter and dust collector, all of which are installed in a vertical frame with steel shell, baking paint and rust prevention, easy to operate and use. Fan adopts centrifugal fan, large air volume, high wind pressure, and adopts noise reduction measures, low noise. Filter using flat cloth bag group, each bag is equipped with spring steel mesh, filtering effect is good. The flyaway mechanism uses the motor to drive the eccentric wheel and connecting rod to make the bag shake and stick to the dust on the surface of the filter bag. The dust collector is equipped with an access door for easy maintenance and bag changing.

The following details the installation precautions of the central dust removal system:

1. The central dust removal system shall be installed near the installation equipment of the machine where dust arises, and the user may equip himself with metal or plastic dust suction pipe and dust suction hood according to the size of the air inlet on the dust collector.

2. Before the mission, the dust collector should check whether the door, the ash door, and the tail system of the air duct can be sealed, so as to avoid leakage and reduce the dust absorption effect.

3. The voltage of the precipitator is three-phase AC 380V. It can be used at the end after connecting the power supply to the internal wire on the precipitator.

4. The electric control box cover of precipitator can not be opened at will during the mission. If the cleaning time needs to be adjusted, or the circuit needs to be reflected, the power supply should be cut off after the shutdown.

Five, according to the nature of dust and capacity of the size, should be regularly vibrating dust cleaning, ordinary cases three to four times per shift vibration, in order to the normal mission of the dust collector.

6. According to the theoretical requirements, stop the dust regularly. When the dust in the dust collector is interrupted, just open the sealed ash door and pull out the drawer.

Seven, in order to set the dust equipment in the mission shape, should be close to the source of dust, ordinary to 1.5 meters to 2.0 meters, the tail pipe can be short, and even reduce the elbow, so as not to add resistance loss.

Eight, dust cover is a key part in the shape of dust collector unit, the use unit should manufacture dust cover according to the shape size of the workpiece dust nature, in accordance with the principle of open, close, smooth, sealing, planning dust cover.

central dust removal system In the work, we can not arbitrarily open its case cover, this is not allowed. When we need to adjust the cleaning time of the machine or check the circuit, the power supply needs to be cut off. In order to be able to work normally, dust cleaning should be done well. The cleaning time can be determined according to the capacity of dust, generally a class to clean three or four times. When we dust, we need to stop the machine and open the sealed door for cleaning.

central dust removal system https://www.kaisenfilter.com/Central-Dust-Collector