Unplugg the hoses

Before installing your bathroom faucet drain stopper, you should know how to remove it. A common mistake is to unthread the lift rod. This could lead to water leaks. This can easily be solved by unplugging the hoses first. Next, you should install a new stopper by following these steps: - Unscrew the nut holding the drain pipe. - Insert a lift rod into the hole and tighten it with a basin wrench. - Attach the ball rod to the spring clip. -Tighten the nut with a wrench and turn it clockwise. -Hold the spout on the top of the sink.

Install the stopper

-Fit the lower drain assembly. The stopper comes with all the parts required to install it. Some come with handles while others require you to buy them separately. -An extension strap is required to secure it on the lift rod. -Tighten the strap to the pivot rod. -Tighten the spring clip. -Tighten the strap again to the sink. -Test the stopper. Press the lever down to plug it.

Tighten the nut

-Place the pivot rod nut on the end of the rod. Tighten the nut on the drain body. -Insert the lift rod strap into the lever of the faucet assembly. -Tighten the screw provided to secure the lift rod. -Tighten the lift rod nut. -Tighten the lever of the faucet assembly. -Lock the stopper with the screw provided.

-Tighten the hinge pin. Ensure the pivot rod is secure. You can unscrew it if necessary. Make sure that the stopper is open enough for water to flow through the spout. Finally, affix a small white ball to the pivot rod to prevent leakage. Voilà! Your copper tap bathroom is now ready to use. It's time to install your drain stopper.

The pop-up drain plug

-Anchor the pop-up drain plug into the hole of the sink. The pop-up drain plug is attached to the drain pipe using a nut. Once the stopper is installed, secure the mounting nut. Then, attach the pop-up rod to the mounting nut. Then, secure the lever with a silicone. And finally, insert the pop-up drain rod into the sink's drainage hole.

-Place the pop-up drain onto the flange of the sink. Place the pop-up in place. Afterward, press the pop-up into the drain flange. Then, close the drain stopper. Then, close the pop-up drain flange. After that, attach the drain. Then, attach the new gasket. Then, attach the flange and test the faucet's seal.
-Plug the pop-up into the sink's drain. Connect the valves and the stopper, using an adjustable wrench, and screw them into place. Then, screw the lever into the sink's drain spout. If the sink drain is leaking, replace the stopper and reconnect the valve. Then, you can reconnect the lever to the spout. -Push the pop-up into the sink.