How to correctly select the Camera Module probe? Camera Module detection is to extend the probe into the detected object for detection. Camera Module probes have higher requirements in special working environments. Then, Miss Shenzhou Mingda, the Beijing Camera Module brand, will answer for you:

1. Choose a camera with a metal material protective layer:

The camera using the surface metal composite material can improve the wear resistance of the camera, and can greatly reduce the damage level of the camera during the entire inspection process.

2. Choose a removable camera and a reliable interface:

In order to be more flexible and convenient in the whole process of inspection, different inspection functions can be maintained according to the selection of different cameras. In addition, the camera should be connected to the camera according to a reliable interface method (such as double external thread structure, etc.). front-end development, which not only ensures the coordination ability in the inspection work, but also ensures the safety of the camera.

3. Select the diameter of the camera according to the length of entry and exit:

Not only, according to the basic principle of camera construction, the larger the diameter of the camera, the higher the definition and the higher the picture quality of the image. At the same time, the larger the diameter of the camera, the longer the length, the smaller the gap after entering the pipeline, the greater the frictional resistance of entry and exit, and the easier it is to jam and damage the camera. Therefore, the longer the probe goes into the inner length of the pipe, the smaller the diameter of the probe is chosen to ensure smooth entry and exit of the probe.

4. Select the probe whose minimum bending radius is smaller than the bending radius of the object to be measured

When the probe enters smoothly, all parts inside the probe will not be damaged by excessive bending. It is also necessary to determine the depth of field range according to the actual working conditions. Because the depth of field of the probe directly affects the clarity of the inspection image.

The above is about how to correctly select the Camera Module probe? This is the detailed introduction. In other words, the selection should be carried out according to the conditions of the specific work. In the initial detailed communication work, full consideration should be carried out to select the appropriate camera, which can not only improve the high efficiency of inspection, but also obtain accurate inspection results. And it can ensure the service life of the camera, which is beneficial to control the cost.

Camera Module https://www.hengal-tech.com/p-Camera-Module/4.html